7
SECTION 3: UNPACKING
Removing Unit From Carton
•
Remove staples, break glue on top flaps or cut tape
at carton end and peel along top flap to open
carton.
•
Remove loose parts if included with unit (i.e.,
operator's manual, hardware pack etc.).
•
Cut corners and lay carton down flat. Remove
packing material.
•
Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
SECTION 4: ASSEMBLING YOUR LAWN MOWER
NOTE: Make sure not to crimp the cables while
removing the loose parts or the entire unit from the
carton.
NOTE: Reference to right or left hand side of the mower
is observed from the operating position.
Tools Required
•
Pair of Pliers
•
Funnel
•
Set of adjustable wrenches
WARNING:
Disconnect the spark plug
wire and ground it against the engine to
prevent unintended starting. Leave safety key
in locked position.
Disconnecting Spark Plug
•
Before setting up your lawn mower, disconnect the
spark plug wire from the spark plug, and ground it to
a bolt, retaining post or V-slot on the engine. See
Figure 1.
Figure 1
Assembling Handle
•
For shipping purposes, the grass bag was placed
on top of the unit. Remove it from the unit and set it
out of the way. See Figure 2.
Figure 2
•
Raise the lower handle, as shown in Figure 2, until
it snaps into place.
•
Raise the upper handle as shown in Figure 2.
•
Tighten the two wing nuts which are already on the
handle. See Figure 3.
Figure 3
NOTE: Make sure to route the cables outside the lower
handle. Also do not crimp the cables while lifting the
handle up.
•
For shipping purposes, the hairpin clip is placed in
the outer hole of the weld pin on the lower handle.
Remove the hairpin clip from the outer hole of the
weld pin.
Spark Plug Wire
Spark Plug
Lift upper
handle
Lift lower handle
Grass Bag
Lower Handle
Upper Handle
Tighten
Lower Handle
Upper Handle
Wing Nut
Содержание Yard-Man 12A-449T402
Страница 19: ...19 NOTES...
