MTD BCR4, Руководство оператора

Страница: 15 / 24

FIGURE 14
FIGURE 15
FIGURE 12
Winding the Inner Reel With New Line
1. Hold the outer spool with one hand and unscrew
the Bump Knob clockwise. Inspect the bolt inside
the Bump Knob to make sure it moves freely.
Replace the Bump Knob if damaged.
2. Remove the inner reel from the outer spool. See
Figure 12.
MAINTENANCE & REPAIR INSTRUCTIONS
15
NOTE:
Always use the correct line length when
installing trimming line on the unit. The line
may not release properly if it is too long.
Single Line Installation
Go To Step 8 for Membrane Line Installation.
6. Take approximately 40 feet (12.2 m) of new
trimming line and loop it into two equal lengths.
Insert each end of the line through one of the two
holes in the inner reel. Pull the line through the
inner reel so that the loop is as small as possible.
See Figure 15.
Slotted
Holes
For Use with Membrane
Line or Single Line
For Use with
Single Line ONLY
Loop
Indexing Teeth
Bump Knob
Bolt
Inner Reel
Spring
Outer Spool
3. Remove the spring from the inner reel. See
Figure 12.
4. Use a clean cloth to wipe the inner reel, spring,
shaft and inner surface of the outer spool.
5. Check the indexing teeth on the inner reel and
outer spool for wear. See Figure 13. If necessary,
remove burrs or replace the reel and spool.
NOTE
: You can only use the membrane line with the
inner reel that contains slotted holes. Single
line can be used on either type of inner reel.
Use Figure 14 to identify the inner reel you
have.
FIGURE 13
7. Wind the lines in tight even layers, onto the reel.
See Figure 16. Wind the line in the direction
indicated on the inner reel. Place your index finger
between the two lines to stop the lines from
overlapping. Do not overlap the ends of the line.
Proceed to step 11.
FIGURE 16