SERIES 830 SELF PROPELLED
4
3.10. Remove the screw and spacer securing cross
bracket to the front and rear height adjusters.
See Figure 3.10.
NOTE:
There are left side and right side gears.
•
If they are replaced on the wrong side, the drive
to that side will not work.
•
Left gears have an “L” stamped on the inside
edge.
•
Right gears have a “R” stamped on the inside
edge.
3.11. Clamp a pair of vice grips on the axle near the
transmission case. See Figure 3.11.
3.12. Using a
10MM
wrench remove the screw from
each side of the axle. This will allow the removal
of the washer, drive gear, dowel pin, and flat
washer. See Figure 3.12.
NOTE:
The drive gears do have an “R” and “L”
on them for side indicators.
3.13. Remove the dust cover.
3.14. Using a 3/8 wrench remove one screw from
each side securing the baffle to the deck.
See Figure 3.14.
Figure 3.10
Screw and Spacer
Figure 3.11
Vice grips
Figure 3.12
Metric Screw
Washer
Drive gear
Dowel
Flat washer
Figure 3.14
Screw securing baffle
