MTD 2005 800 Series, Руководство по обслуживанию

Страница: 7 / 14

SERIES 830 SELF PROPELLED
3
NOTE: Torque is 450-600 inch pounds
3. TRANSMISSION / CONTROL CABLE
REMOVAL
3.1. Disconnect and ground the spark plug wire.
3.2. Drain the fuel tank or place a piece of plastic
under the fuel cap to prevent gas from leaking.
3.3. Remove the small cover from the control hous-
ing using a phillips screwdriver.
3.4. Disconnect the drive cable from the drive control
handle. See Figure 3.4.
3.5. Remove the spring bracket cover.
3.6. Move the height adjuster to the highest position
reducing tension on the height adjuster spring.
Blade stack up
Blade bolt Blade bell support
Blade
Blade adapter
Flat washer
Spring washer
Spacer
Lower engine pulley
Upper engine pulley
Figure 3.4
Drive cable
Drive control handle
3.7. Using some recoil rope or a spring puller CARE-
FULLY disconnect the spring. See Figure 3.7.
3.8. Support the rear of the unit with a 4 x 4 or equiv-
alent.
3.9. Using a 9/16 socket remove the rear wheels.
See Figure 3.9.
Figure 3.7
Height adjuster
spring
Recoil rope
Figure 3.9
4 x 4 Block
Rear wheel