SERIES 830 SELF PROPELLED
2
1.5.
Remove belt from engine pulley. See Figure 1.5.
1.6.
Pushing belt toward the transmission, remove
belt from transmission pulley.
1.7.
Pull belt forward though baffle. See Figure 1.7.
NOTE:
Belt will fit over blade.
1.8.
Install the belt by slipping it over the blade.
1.9.
Push the belt though baffle toward transmission
1.10. Slip the belt over the transmission pulley.
NOTE:
Pulling the belt forward slightly while slip-
ping the belt over rear belt keepers will help
keep the belt on the pulley.
1.11. Slip the belt over engine pulley. See Figure 1.11.
CAUTION:
Check to make certain that the belt is
within the belt keepers.
1.12. Reinstall the screw securing baffle to the deck.
2.
BLADE REMOVAL
2.1.
Disconnect and ground the spark plug wire.
2.2.
Drain the fuel tank or place a piece of plastic
under the fuel cap to prevent gas from leaking.
2.3.
Position the mower with the front elevated.
2.4.
Secure the blade from rotating.
NOTE:
Correct order is as follows:
Starting from the engine and working out:
1) Upper engine pulley
2) Lower engine pulley
3) Engine spacer.
4) Spring washer.890 x 1.70 x.048 - check orientation
5) Flat washer.885 x 1.850 x.060
6) Blade adapter
7) 21” Blade
8) Blade bell support
9) Blade bolt 3/8-24 x 1.50
Figure 1.5
Belt
Figure 1.7
Baffle
Belt
Figure 1.11
Belt
Transmission
