MTD Gold 31AS2T5E504, Руководство оператора

Страница: 8 / 36

8 S
ection
3— A
SSembly
& S
et
-U
p
2. Remove the hex washer screws in the chute base. See Fig. 3-4.
3. Align the holes in the chute base with the holes in the
lower chute and secure with the previously removed hex
washer screws. See Fig. 3-5.
Installing the Recoil Starter Handle
On some models it may be necessary to install the recoil starter
handle. If your handle is not pre-installed follow the directions
below to install it.
1.
Remove the eye bolt and handle knob from the manual
bag.
2. Place the eye bolt and handle knob on the upper handle as
shown in Fig. 3-6. Do not fully tighten the hardware until
instructed to do so.
NOTE: The opening of the eye bolt should face toward the
back of the snow thrower.
3. Slowly pull the recoil starter handle up towards the eye
bolt.
4. Slip the recoil starter rope into the eye bolt from the back
of the snow thrower. See Fig. 3-6.
5. Securely tighten the eye bolt and handle knob.
Figure 3-5
Figure 3-6
Figure 3-4
B
A
Eye Bolt
Handle
Knob
Recoil Starter
Handle
Set-Up
Adding Fuel & Oil
Refer to the Engine Operator’s Manual packed with your snow
thrower for information on adding fuel and oil.