MSV PlayTec, Руководство по эксплуатации, Страница: 5 / 20

5
The uniformity of the throwing wheels depends on the homogeneity of the balls you
use. The machine will throw lightly used balls faster than old worn balls. A mixture of
old and new balls should therefore be avoided.
Irregular throws can also be caused by a lot of dirt and printing ink on the rubber
coating. In such a case, clean the throwing wheels as described in the chapter
"Cleaning". Please do not use wet balls!
Mounting
1. Place the machine on the floor.
2. Pull out the pull rod and place the ball basket over it until it is firmly seated.
Set up and start
If you are using pressure less trainer balls, place the machine in the middle of the
baseline or a little further behind it depending on the bounce/throw behavior.
Pressure-based balls bounce more - in this case, place the machine one to two
meters behind the baseline. Basically, the length of the balls can be additionally
regulated by the speed and location of the machine. After you press the start button
on the machine, the throwing wheels start to turn, but not yet the rotor that feeds the
balls to the chute. Only when you press the ON/OFF (Power) button on the remote
control and then the Start/Stop button, the rotor starts to turn. Please note that the
machine starts with the ball output with a time delay.
The Power key is only used to switch the remote control (not the machine) on or off
(press for 3 seconds). When switching off, please press until nothing is visible on the
display.
With the opposite Work/Pause button you can start, stop or pause the ball feed.
The display shows the ball throwing speed from 20 to 140 km/h at the top. Press the
Speed key to change the value.
Press the
Fixed Point key to end a program. So always press this key before
pressing any other key.