
© MSR Electronics GmbH, 2022-02-22. All rights reserved.
7
MSR Electronics GmbH • Mettlenstrasse 6 • CH-8472 Seuzach • Switzerland
Phone. +41 52 316 25 55 • [email protected] • www.msr.ch • www.datalogger.shop
START Data Loggers MSR63, MSR64
Check the status of the logger:
Press the START button once and check the LED indication:
LED Indication
green LED flashes twice
green LED flashes once
green LED flashes once
red LED flashes once
red LED flashes twice
yellow LED flashes twice
Data Logger Status
waiting to START (press START button for 5 seconds to START)
STARTED (in delay start mode)
recording – OK (no alarm condition)
recording – alarm condition
STOPPED
low battery
START the data logger:
Keep the START button pressed continuously for 5 seconds until the green LED flashes, followed by a flashing of the red and green LED»s. Once the red
and green LED»s stop flashing you may check the status by pressing the START button again for once which will flash the green LED for once confirming the
MSR data logger has been started successfully.
Note: Do not use the data logger if no LED is ON or if the red LED flashes twice after pressing the START button. Replace the battery if the yellow
LED flashes twice. Avoid using the logger without battery replacement.
LED
I
NDICATION
LED
I
NDICATION
T
AMPERPROOF
&
R
OBUST
C
ASE
2.0
A-T
YPE
USB
C
ONNECTION
T
AMPERPROOF
&
R
OBUST
C
ASE
2.0
A-T
YPE
USB
C
ONNECTION