BULB INSTALLATION
BULBS NEED TO BE INSTALLED
BEFORE USE:
To avoid damage during
shipping units are shipped without bulbs
installed. The bulbs are carefully packed
and are located inside the unit under the
fan cover. To access the bulbs
( See
Fig. 1 )
unplug the fan wire plug, carefully
remove the temperature sensor / bracket
by removing 3 brass thumb nuts and set
it aside. Remove 7 screws and lift off
cover.
UNPACK AND INSTALL BULBS ONE
AT A TIME, HANDLING THEM BY THE
ENDS ONLY.
Feed bulb wires, one side at a time
through outer holes ( next to bulb clips)
in reflector pan and insert ceramic ends
into clip.
( See Fig. 2 ).
Install remaining
bulbs
WIRING BULBS:
VERSI FLASH TC And TC – 1000 Temp control units have 4 ceramic blocks for bulb
wiring. The center zone ( zone 2 ) uses 2 blocks. This is to avoid any wires from
blocking the cutout for the temp sensor. Take care to route wiring around this cutout
when hooking up bulbs!
FAN WIRE PLUG
BRASS
THUMB
NUTS
SCREWS 7 PLACES
FIG. 1
FIG. 2
BULB WIRES
3