
SAFE WORKING CONDITIONS
16
4.8 Hazards and precautions
1.
In order to avoid damaging the centrifuge in any way, the user should read
and understand the instruction manual before operating the Kestrel.
2.
Un-trained personnel should never operate the centrifuge.
3.
The centrifuge must not be transported with the rotor mounted on the motor
shaft.
4.
The centrifuge should only be used in conjunction with original rotors and
spare parts.
5.
If the user discovers a fault with the centrifuge, a qualified service engineer
should be contacted through MSE CENTRIFUGES Ltd.
6.
Do not switch the centrifuge on if it is not installed properly or if the rotor is
not fitted correctly.
7.
The centrifuge must not be operated in places where there is a risk of
extreme hot or cold temperatures.
8.
Do not use flammable or highly volatile materials in the centrifuge.
9.
Users are advised to take extreme care when centrifuging toxic or
contaminated substances.
10. The appropriate decontamination procedures should be adhered to when
cleaning any parts of the centrifuge that has been in contact with any toxic or
hazardous material.
11. Do not open the lid manually when the rotor is still turning.
12. Do not exceed the load limit set by the manufacturer.
13. Rotors are intended for fluids of average homogeneous density equal to 1.2
g/cm
3
or smaller when centrifugation is carried out at maximum speed.
When fluids of higher density are used, then it may be necessary to reduce
the speed.
14. Do not use the rotors that have signs of corrosion or other mechanical
defects.
15. Do not use highly corrosive substances, which could cause material
impairment and damage the mechanical properties of rotor.
16. Do not use plastic rotors and accessories that have not been recommended
by MSE CENTRIFUGES Ltd.
17. Only commercial plastic test tubes should be used.
18. Ensure that the test tubes are in good condition and show no signs of
damage or wear.
19. Do not run the centrifuge without the rotor.
20. Do not run the centrifuge without the lid on the rotor unless using the 6 x
15ml angle rotor.
21. Do not move the centrifuge whilst in use.
22. Do not place objects on the centrifuge.