Section 9
ZGARD CX II Controller
Operation & Configuration Set Up Menu
14. Press the MENU key.
15. The
ZONE ASSIGNMENT
menu will appear. The second line of the display shows the current sensor # to
be assigned with the corresponding zone number. The following choices are available:
15.1.
Change sensor #:
Press the
or
key to associate the sensor # with the zone #.
15.2.
Change zone #:
Type the new zone (1 to 8) number and press ENTER to accept.
Z O N E A S S I G N M E N T
S E N S O R :
1
Z O N E :
1
< , >
: S E N S O R
1 . . 8
: Z O N E
E N T E R : A C C E P T
16. Press the MENU key.
17. The
EXTERNAL RELAY CARDS
menu will appear. The second line of the display shows the current
selection of active external relay cards. Relay card 0 is the internal relay card and is always shown. If other
relay cards are connected to the system, their address (1-9) determines their location in the relay map.
17.1. Press the
or
key to initiate a scan of all external relay card addresses
E X T E R N A L R E L A Y C A R D S
A C T I V E :
0
1
< , > :
R E - S C A N
E N T E R : U P D A T E
17.2. As the ZGARD CX II scans for external relay cards, it displays all cards that are found
E X T E R N A L R E L A Y C A R D S
A C T I V E :
0
1
F O U N D :
0
1
2
< , > :
R E - S C A N
E N T E R : U P D A T E
17.3. Press ENTER to accept all found relay cards. Any newly found relay cards will not be available to the
system until ENTER is pressed to update the ZGARD CX-II
18. Press the MENU key.
The
FAULT RELAY ASSIGNMENT
menu will appear. The second line of the display shows the current
relay number (1-40) and its network location (internal or external card and relay number on that card). The
third line shows the zone(s) to which this FAULT relay is assigned. A relay may be assigned to multiple
zones.
18.1. Press the
or
key to move through all of the relay numbers.
18.2. Press 1 through 8 to add or delete a zone that this FAULT relay is supposed to get activated for
18.3. If a relay number is not present because its external card is not found on the network, the message
RELAY NOT AVAILABLE will be displayed on line 3.
F A U L T R E L A Y A S S I G N M E N T
R E L A Y :
1 ( I N T E R N A L R E L A Y :
1 )
Z O N E :
1
2
< , > :
R E L A Y
1 . . 8 : T O G G L E Z O N E
9.3
