26
Donning
GB
G1 Integrated SCBA System
6
Donning
WARNING!
Before entering the hazardous area, the device must be put on. The device must be worn on
the body at all times and not removed while in the hazardous area to avoid electrostatic
discharge in potentially explosive atmospheres.
Before entering the hazardous area, check the complete G1 electronic devices for mechanical
damage including damage to the conductive coatings of the housings.
If the SCBA does not function properly as described in this section, the SCBA must be
removed from service and must be checked and corrected for proper operation by an MSA
trained or certified repairperson before using.
The full face mask may not seal properly with your face if you have a beard, gross sideburns
or similar physical characteristics. An improper facial seal may allow contaminants to leak into
the full face mask, reducing or eliminating respiratory protection. Do not use this device if such
conditions exist.
The full face mask seal must be checked before each use.
A nosecup must be installed in the full face mask.
In order to guarantee a proper fit for those wearing glasses, the G1 spectacle kit
must
be worn
since ordinary glasses
cannot
be worn under the full face mask.
Never remove the full face mask except in a safe, non-hazardous, non-toxic atmosphere.
Users must wear suitable protective clothing and precautions must be taken so that the device
is not exposed to atmospheres that may be harmful to it.
Failure to follow these warnings can result in serious personal injury or death.
6.1
Preparation
The device must have passed all visual inspections and functional tests (see previous chapters)
before use.
(1) Ensure that the cylinder is fully pressurized.
(2) Check cylinder connection:
Threaded connect:
Check that the handwheel is hand-tight (no tools).
alphaCLICK 2 (Quick connect):
Ensure secure connection by pull on quick connect coupling.
(3) Pull on the cylinder band assembly to ensure the cylinder band is attached securely.
(4) Only applicable when control module and power module are present: Check battery status
by pressing and holding both reset buttons until the battery icon appears.
The battery icon will shut off after approximately 10 seconds.
(5) Loosen the shoulder straps as far as possible.
(6) Loosen the waist belt straps as far as possible.
(7) Only applicable when control module and power module are present: Tag in the user's infor-
mation with ID Tag. See "Personnel ID Tag" section for more information.
