MS CX-40, Руководство по эксплуатации самолета

Страница: 5 / 52

Controller
Important Overview
The CX40/CX50 DRONE controller
can be used is 2 modes: (the pre-setting is mode 1) Mode 1: The left stick controls pivitol
turning, the right stick controls lateral flight. Mode 2: The left stick controls lateral
flight, the right stick controls pivitol turning. Press and hold the Control Mode switch
until beep sounds to toggle between controller modes
The
CX40/CX50 DRONE has three different programmed speeds:
Toggle though these three speed settings using the Speed Selector button. Press to hear
one beep for low speed, two beeps for mid speed, three beeps for high speed
The CX40/CX50 DRONE has Auto-Trim Function (fine-tunes all rotors balance):
Use this function if your CX40/CX50 DRONE is not hovering in a set spot.
To auto-trim all rotors: With the CX40/CX50 DRONE turned on, and set it on a level
surface, turn on the controller while pushing in the Auto-Trim button.
Left Stick: While in Mode 1, up / down, left / right pivot turn.
While in Mode 2, up / down, left / right side fly.
Right Stick: While in Mode 1, forward/reverse, left / right side fly.
( CX-40) While in Mode 2, forward/reverse, left / right pivot turn.
Right Stick: While in Mode 1, down, left / right side fly.
( CX-50) While in Mode 2, down, left / right pivot turn.
Trim Slider A: No function
Trim Slider B: While in Mode 1, used for left / right pivot turning, manual fine-tuning.
While in Mode 2, used for left / right side flight, manual fine-tuning.
Trim Slider C: While in Mode 1, used for left / right side flight, manual fine-tuning.
While in Mode 2, used for left / right pivot turning, manual fine-tuning.
Trim Slider D: Used for forward / reverse flight, manual fine-tuning In modes 1 and 2.
Speed Select/Auto-Trim button:
Press the Speed Select button to toggle through speed options. Slow speed, one
beep. Middle speed, two beeps. High speed, three beeps. To auto-trim, turn on
the controller while pushing in the Auto-Trim button.
LED on/off, Control Mode Switch:
A: Press once for LED lights on/off toggle function.
B: Press and hold until beep sounds to toggle between Controller modes
9.Power Switch: Slide forward to turn on controller, and back to turn off.
Power Switch
Speed Select
Auto-Trim
Throttle / Left Stick
Trim Slider B
Trim Slider A
LED on/off,
Control Mode Switch
Right Stick / Rudder Trim
Slider C
Taking Photo
Recording Video
Trim Slider D