MS CX-40, Руководство по эксплуатации самолета

Страница: 3 / 52

Flying Precautions
1 .Keep small parts out of the reach of children, to avoid choking hazard.
2. The CX40/CX50 DRONE is powerful, when taking off, move the throttle stick forward
gradually,to avoid it's rising too fast.
3. After flight, disconnect the Li-Poly battery from CX40/CX50 DRONE first, then turn off
the controller. 4. Do not put the battery in high temperature or near heat source
5. Note, to avoid injury or damage, the CX40/CX50 DRONE should not be flown nearer
than 2 meters / 7 feet from people or other obstacles.
6. Children should fly the CX40/CX50 DRONE under adult supervision only. Always keep
the CX40/CX50 DRONE in clear sight while flying.
7. Always turn off the power of the controller and CX40/CX50 DRONE when not in use.
Preparing To Fly
1. Make sure that flight area is clear of people or other obstacles
2. Turn on the controller, push the throttle lever up and down, a beep will sound.
3. Connect the battery to the CX40/CX50 DRONE using the 2 red connectors. The
CX40/CX50 DRONE will go into auto detection mode, (the indicator light on the circuit
board flashes rapidly in this mode). At this time, place the CX40/CX50 DRONE at a level
position. When the indicator light flashes at about once per second, the CX40/CX50
DRONE is ready to fly.
4. Before flight, unlock the dron first by pushing the throttle stick forward and then push
it back, after the LED stops flashing and is always on the dron is unlocked and ready to
fly.
5. Push the throttle lever slowly forward, the CX40/CX50 DRONE will take off.
Battery Protection
1. The CX40/CX50 DRONE is equipped with low-voltage protection: When it's battery is
low, the programmed control system will stop electrical supply to CX40/CX50 DRONE'S
rotors. The battery then needs charging to allow the CX40/CX50 DRONE to fly again.
2. The CX40/CX50 DRONE is equipped with over-current protection: When the copter
blades are jammed, to prevent damage, the control system will stop electrical supply
to rotors.
Maintenance
1. Clean the CX40/CX50 DRONE with clean, dry soft cloth only.
2. To avoid irreparable damage, keep the CX40/CX50 DRONE dry and away from water.
Do not fly in rainy conditions
3. Check the CX40/CX50 DRONE and accessories for damage. If damage is found, do not
use the CX40/CX50 DRONE until it is repaired.