MRV Communications MRW55, Руководство пользователя

Страница: 183 / 244

PPPoE Commands
7-57
7
ip pppoe
This command enables Point-to-Point Protocol over Ethernet (PPPoE) on the
Ethernet interface. Use the
no form to disable PPPoE on the Ethernet interface.
Syntax
ip pppoe
no ip pppoe
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
The access point uses a PPPoE connection, or tunnel, only for management
traffic between the access point and a remote PPPoE server (typically at an
ISP). Examples of management traffic that may initiated by the access point
and carried over a PPPoE tunnel are RADIUS, Syslog, or DHCP traffic.
Example
pppoe ip allocation mode
This command specifies how IP addresses for the PPPoE tunnel are configured on
this interface.
Syntax
pppoe ip allocation mode { automatic | static }
• automatic - IP addresses are dynamically assigned by the ISP during
PPPoE session initialization.
• static - Fixed addresses are assigned by the ISP for both the local and
remote IP addresses.
Default Setting
automatic
Command Mode
Interface Configuration (Ethernet)
Command Usage
The IP address allocation mode depends on the type of service provided by
the ISP. If automatic mode is selected, DHCP is used to allocate the IP
addresses for the PPPoE connection. If static addresses have been assigned
to by the ISP, these must be entered using the
pppoe local ip and pppoe
remote ip commands.
MRW55##(if-ethernet)#ip pppoe
MRW55##