MRMC MRMC-2118-00, Быстрый старт

Страница: 20 / 36

Round Rail Quick Start Guide
16
Mounting Talos on the Track
1. Roll the rig to a position just off the end of the track, raise the rig on
its wheels high enough to go over the track using the wheel cranks,
and rotate the rig on its wheels to be the correct way around so that
the track motor gear on the rig underside is on the toothed side of
the rack.
Do not engage the teeth yet; just make sure the rig is the
correct way around for the track.
2. On the underside of the rig, remove the pinch wheel if you haven’t
already done so and push the track motor out of the way on its
sliding bearings, so that the track motor gear will not interfere with
the Rack on the track. (For details of removing the pinch wheel,
follow the procedure on page 19 in reverse order.)
Do not slide the
pinion gear too far away from the rack when moving it into place,
the rear (inner) track motor mounting bolt will hit the racking as
you drop the rig down, preventing it from settling onto the
bearings.
3. Push the rig on its wheels over the track about a metre, being careful
not to push the track motor gear against the rack while moving.
4. Carefully lower the rig onto the track, ensuring that the track motor
gear on the underside of the rig clears the rack.
5. Apply the brakes to the wheels to keep them from pivoting against
the track (the brakes affect both rotation and pivot), and raise the
wheels off the ground so the full rig weight is taken by the track.