How To Use The Buttons
Page 8
mrcool.com
SILENCE
FP
MODE
FAN
TE MP
ON/OFF
TIME R
ON
TIME R
OFF
1
LED FOLLOW
ME
TURBO SELF
CLEAN
SWING DIRECT
S LE E P
Dehumidifying Operation
Ensure the unit is properly wired to an appropriate power source and
the power is on.
1.
Press the
MODE
button to select
DRY
mode.
NOTE
In the
DRY
mode, you cannot adjust the fan speed. It will be
automatically controlled. You are also not able to control the
temperature setting. In
DRY
mode the unit will run non-stop and
does not operate based on temperature or humidity.
1
MODE
FAN
TE MP
ON/OFF
TIME R
ON
TIME R
OFF
SILENCE
FP
LED FOLLOW
ME
TURBO SELF
CLEAN
SWING DIRECT
S LE E P
Timer Operation
Pressing the
TIMER ON
button will activate the auto-on time for the
unit. Follow the steps below to set and adjust this function:
1.
Press the
TIMER ON
button. The remote control shows
TIMER ON
,
the last auto-on setting time, and the signal "H" will be shown on the
LCD display. Now it is ready to reset the auto-on time to
START
the
operation.
2.
Push the
TIMER ON
button again to set desired auto-on time. Each
time you press the button, the time increases in 30 minute
increments between 0 and 10 hours and by 60 minute increments
between 10 and 24 hours.
3.
After setting the
TIMER ON
, there will be a one second delay before
the remote control transmits the signal to the air conditioner. After
approximately another 2 seconds, the signal "H" will disappear, and
the set temperature will reappear on the LCD display window.
To Set The Auto-On Time
