Handling The Remote Control
5
Page 12
mrcool.com
Location Of The Remote Control
Using the Remote Control Holder
Replacing the Batteries
Use the remote control within a distance of 26.25 ft (8 m) from the appliance,
pointing it towards the receiver. Reception will be confirmed by a beep.
• The remote control can be attached to a wall or pillar by installing a remote control holder.
• Before installing the remote control holder, check that the air conditioner receives the
signals properly.
• Install the remote control holder with two screws. As shown in the image to the right.
• For installing or removing the remote control from the holder, move it up or down in the
holder.
The following cases signify exhausted batteries. To fix this, replace the old batteries with
new batteries.
• Receiving beep is not emitted when a signal is transmitted from the remote to the unit.
• Indicator fades away.
The remote control is powered by two dry batteries (R03/LR03X2) housed in the rear
compartment beneath the protective cover. To replace the batteries, follow these steps:
CAUTION
• The air conditioner will not operate if curtains, doors or other materials block the signals from the remote control to
the indoor unit.
• This remote control emits infrared (IR) signals to control your air conditioner via the IR receiver located in the indoor
unit. Be aware that other devices that emit an IR signal or contain an IR receiver may cause interference. If this
occurs, take immediate corrective action and contact MRCOOL.
DO NOT
allow any liquid to enter the remote control.
DO NOT
expose the remote control to direct sunlight or heat. If the infrared signal receiver on the indoor unit is
exposed to direct sunlight, the air conditioner may not function properly. Use curtains to prevent the sunlight from
shining directly on the receiver.
1.
Remove the cover on the rear of the remote control.
2.
Remove the old batteries and insert the new batteries, being sure to place the (+) and (-) ends correctly.
3.
Reinstall the cover.
CAUTION
NOTE:
When the batteries are removed, the remote control erases all of the previous programming. After
inserting new batteries, the remote control must be reprogrammed.
DO NOT
mix old and new batteries or batteries of different types.
DO NOT
leave the batteries in the remote controller if is not going to be used for 2 or 3 months.
DO NOT
dispose of batteries as unsorted municipal waste. Collection of such waste separately is
necessary because it requires special treatment to be disposed of properly.
DO NOT
drop the remote control. Handle it with care.
DO NOT
place heavy objects on the remote control, or step on it.
