Level Reading
Bolt the wall mount
onto the wall
Drill pilot holes
Installation Of The Bracket
Page 5
mrcool.com
3
To properly install the bracket, you will need to select a strong
and permanent installation location that can support the weight
of the bracket and the condenser. Tools needed: Pencil (to
mark mounting hole location), hand-held drill, and a level.
1.
Using Wall Plate A (with lip of plate at the bottom), place
it against the wall to determine the correct mounting
location. Use a level to align the wall plate and ensure it
is parallel with the ground. Once level, use a pencil to
mark the three holes on the surface it is to be mounted
to. Please refer to
Fig. 3.1
.
2.
Once the holes are marked and aligned, using a hand-held
drill, with a 5/16 in (8 mm) drill bit, drill holes into the
mounting surface with a depth of approximately 2-3/4 in
(70 mm).
NOTE: If you are drilling into any type of masonry
(concrete, brick, etc.) please use a masonry drill bit
which is specifically made to drill into those types of
materials.
3.
Then, place the wall plate against the wall and align the
mounting holes. Insert bolts, component W-A, through the
wall plate and into the mounting holes. Tighten the bolts to
secure the wall plate to the mounting surface.
DO NOT
overtighten the bolts
.
4.
Now, using the support bracket mounts you assembled in
the first section, you will now slide them onto each side of
the mounted wall plate. They will need to be slid into the
correct position on the wall plate to accomodate the
bottom of the condenser. Please refer to
Fig. 3.1
.
NOTE: Various size condensers can mount to this bracket.
The bracket support mounts have the ability to slide on
the wall plate to fit your application. It is important to
determine where the support bracket mounts should be
mounted before proceeding to the next step.
Fig. 3.1
Component W-A
2-3/4 in
70 mm
5/16 in
8 mm
