Installation Of The Bracket
Page 6
mrcool.com
CAUTION
Installers must verify that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
5.
With the support bracket mounts in the correct position, you will now use a pencil to mark the bottom hole
on each of the support mounts. Once marked, remove the support bracket mounts from the wall plate.
Please refer to the image below.
NOTE: Component D, that you installed earlier in the installation, is actually a vertical leveling screw.
If you are mounting the bracket to a wall that has an uneven exterior surface (such as vinyl siding),
and find that the upright portion of the brackets (component C) does not sit vertically straight
against the wall, you can use this screw to adjust it. It acts as a bumper that sits against the wall and
can be adjusted in and out. Please refer to the image below.
6.
You will now drill the holes you just marked on the mounting surface using the same drill bit and drill depth
used when mounting the wall plate.
7.
Then, slide the support bracket mounts back on the wall plate and align the mounting holes. Now, insert the
bolts from component W-A into the mounting holes and tighten them.
DO NOT
overtighten the bolts.
Support Bracket
Mounting Holes to
Drill Into Mounting
Surface
Component D
