LCEN-401P
8
⚫
Do not exceed the actual capacity allowed in the user manual.
8.3 Keep the tubes balanced
⚫
Although the centrifuge can accept sample balancing by eye, we recommend that you keep this
centrifuge in a well-balanced condition to extend its life expectancy.
⚫
Never intentionally run the centrifuge under an unbalanced condition even though the allowable
imbalance is not exceeded.
8.4 Inspect the rotor
Check the rotor for corrosion or scratches before using.
CAUTION
⚫
If any abnormality such as corrosion or scratches are found, stop using the rotor and contact our
service center.
⚫
Only manufacturer’s rotors must be used with the unit.
8.5 Symmetrically load centrifuge tubes into rotor
CAUTION
⚫
Make sure the rotor lid is securely fixed on the rotor, as well as the rotor and shaft are tightened.
Otherwise, the rotor may be moved off while rotating and cause damage to the centrifuge and rotor.
⚫
Firmly tighten the rotor lid to the rotor.
9. Operation
9.1 Normal operation
Turn on the power switch, centrifuge will display the running interface last time after passing the
self-diagnostic checks.
CAUTION
⚫
Do not overload samples into the centrifuge which will cause leaking.
CAUTION
⚫
Do not push or lean against the centrifuge while it is running.
⚫
Do not run the centrifuge when fragments or sample solutions are left in the centrifuge chamber.
Always keep the centrifugal chamber clean.
⚫
If the centrifuge makes strange noise during operation, stop it immediately and contact our service
center. Notify them of the warning code if displayed.
