6. SALT MEASURING and
CALIBRATION
6-1 Salt measurement
1)Prepare the Probe ( CDPB-03, same probe as the
conductivity measurement, refere to Fig. 2, page 9 ),
install the " Probe Plug " ( 5-1, Fig. 2 ) into the "
Probe Socket " ( 3-13, Fig. 1 ).
2)Power on the meter by pressing " Power Button "
( 3-2, Fig. 1 ) once.
Select the Meter's measurement Mode to " SALt ", refer
to Chapter 4, page 8.
3)Hold the " Probe Handle " ( 5-2, Fig. 2 ) by hand
and let the " Sensing head " ( 5-3, Fig. 2 )
immersed wholly into the measured solution. Shake
the probe to let the probe's internal air bubble drift
out from the sensing head.
Display will show the Salt values ( % weight ).
6-2 Calibration
If the conductivity range already make the calibration
completely then the Salt measurement is not necessary to
make the calibration again.
13
