mr
.
steam
®
Controls
__________________________________________________________________
5
3a
3b
4a
4a
5b
5a
Locating the Control
Determine the desired installation location of the control. The iSteam 2.0
controls are designed to be installed inside or outside the steam room
as a matter of personal preference. If the control is installed inside
the steam room:
• Locate the control 4-5 feet above the floor near the bather seating area.
• The control features an integral temperature sensor. Locate the control in a
location representative of the desired steam bathing temperatures. Do not
locate the control above or near the steam head or direct steam emissions.
• Locate the control on a vertical wall.
• The control and AudioWizard
™
cables are 30 feet. Insure that the control,
steam generator and optional AudioWizard are located accordingly.
IMPORTANT NOTES:
• If required, contact Mr.Steam to purchase an optional 60’ iSteam 2.0
control cable part number 104117-60.
• A 60 foot cable is NOT available for AudioWizard.
• If the control is installed outside the steam room a Remote Temperature
Probe Part Number iMSTS must be installed inside the steam room.
Refer to the iMSTS installation manual before installing the control.
• Insure Mr.Steam steam generator is iSteam 2.0 compatible and has
a serial number 930030 or higher.
Installation with Optional Rough-In Box
A rough-in box is supplied with iSteam 2.0 for new construction.
The rough-in box will allow precise location of the iSteam 2.0 control and
provide a secure and easily identifiable place for the cables while the steam
room is being constructed.
STEP 1
Take the rough-in box out of the package. Remove the two screws (1a )
and place them in the top and bottom wings of the rough-in box (1b).
STEP 2
Select a KNOCK-OUT (2a) to route the control cable into the box.
Use a second KNOCK-OUT if the optional AudioWizard is used.
STEP 3
Line up the two TABS (3a) on the right of the box against a stud.
These TABS help locate the box to sit PROUD of the stud (3b).
STEP 4
SCREW (4a) the two supplied screws into the stud.
STEP 5
Route the CONTROL CABLE (5a) through the back of the rough-in box
and clip it under one of the TABS (5b) that previously held the screws.
The two ends of the control cable are the same.
1a
1b
1b
2a