17
Installation Instructions for eTempo/Plus
®
(cont.)
Step 4
Firmly connect the control connector to the control. Turn on power
to the steam generator and test the control to verify correct
connections. Test per the instructions on pages 21-22. Proceed
with installation and verification of proper control function.
Step 5
Remove & discard peel-off paper to expose
adhesive liner as shown in Diagram
3
.
Step 6
Run a bead of silicone (provided) as shown to the
C
shaped groove as shown in Diagram 4.
IMPORTANT: Do not apply excessive amounts of silicone.
DO NOT APPLY SILICONE TO ANY OTHER PARTS OF THE CONTROL
INCLUDING THE ADHESIVE GASKET.
Step 7
Insure the mounting surface is clean and dry as required for good adhesion.
Apply silicone into the hole in the wall as required to create a moisture seal.
Hold the control with the LED display in the 12 o'clock position and press the
control against the wall until the adhesive sticks and holds firmly as shown in
Diagram
6
.
IMPORTANT: Two registration marks are provided to
facilitate level installation. The marks are located at the
3 o'clock and 6 o'clock positions on the back side of the
control. Use a level as required.
DIAGRAM 3
DIAGRAM 4
DIAGRAM 5
DIAGRAM 6
mr
.
steam
®
club therapy
®
eTempo Controls
______________________________________________________________________________
