Basecamp, Inc.| Portable Shower
Operating Instructions and Owner’s Manual
5
OPERATING TAP
INSTRUCTIONS(Model XW18 Only)
1.
Swing the tap away from its storage position and locate to
-
wards the side of the appliance and locate a basin or bucket
beneath and locate the water flow to the central position.
2.
The water temperature can be adjusted by moving the flow
valve between “Min & Max” as this will slow or increase the
water flow resulting in an increase or decrease in the outlet
temperature.
IMPORTANT: Running water for an extended period of time
in the low flow position (
-
) can trigger the High Limit Switch
causing burner to stop.
APPLIANCE POWER & CHARGING
(Model XW18)
1.
The appliance is fitted with a 15V 5A/hr battery pack and can
be recharged with the AC adaptors /supplied.
2.
Check the “Battery Indicator” that sufficient power is
available, if not connect to the AC adaptor.
3. Attach the shower hose using the Quick Connect Fitting. Model
XB13 attaches to inlet connection located on the front side of
shower. (Fig. 2)
Model XW18 attaches to the faucet. (Fig. 3)
4. Submerge the pump in a suitable reservoir of water. Maintain
pump fully submerged in water as the pump is being used as
pump motor can be damaged if not.
DO NOT use water direct from rivers, lakes sediments
from these bodies of waters can damage pump and the
appliance. DO NOT use in ocean in which salt water can
damage the pump and appliance.
WARNING:
there are possible health effects from microbes
that might be present in these bodies of waters rivers, lakes
and oceans.
5. Screw propane clockwise into shower regulator then depress
the power button,the electronic ignition should be heard
igniting the burner. The XB13 model press the start button
on the pump power pack.
6. Take care to measure the temperature of the water from the
shower head, the temperature can be adjusted by turning the
temperature control knob until the desired level is reached.
IMPORTANT – Water remaining in the heat exchanger while the
flow is stopped may become hot. When the flow is resumed the
user must check the temperature output to ensure that it is
suitable and not too hot.
Fig. 2
Fig. 3
XB13
XW18
