MQ Multiquip J36E2, Руководство по эксплуатации и запасным частям

Страница: 7 / 10

ELECTRIC WALK-BEHIND TROWEL — SERVICE BULLETIN TR20190823 — REV. #1 (10/16/19) — PAGE 3
4. Remove and discard the existing power cable and
fitting (Figure 4).
NEW PLUG INSTALLATION
1. Locate the 230V pigtail assembly (P/N 30718). Strip
the insulation back 1/4" from the end of each of the
three pigtail assembly wires (Figure 5).
Figure 5. Install Ring Terminals
2. Place a ring terminal (P/N 30096) onto the end of
each of the three pigtail assembly wires and crimp.
See Figure 5.
0.25"
230V PIGTAIL
ASSEMBLY
P/N 30718
RING TERMINAL
P/N 30096
3. Connect the three pigtail assembly wires inside the
main switch box as shown in Figure 6.
Figure 6. Install New Power Cable
4. Finish installing the 230V pigtail assembly (P/N 30718)
by inserting the push-on liquid-tight connector into
the open hole on the main switch box. Make sure the
connector is fully seated in the hole. See Figure 6.
5. Reinstall the switch cover using the two screws that
were removed earlier.
L3
GND
L1
CONNECT
3 WIRES
MAIN
SWITCH BOX
230V PIGTAIL
ASSEMBLY
P/N 30718
PUSH-ON
CONNECTOR
INSERT INTO
SWITCH BOX
HOLE