23
1.
Press the Right key to clear the datalog. The display asks, ‘Clear Datalog?’
2.
Press the Left (Esc) key if you do not want to clear the datalog.
3.
Press the Up key if you want to clear the datalog. When it has been cleared, the display shows
‘Datalog Cleared!’ and moves to the next sub-menu, Interval.
Interval
Intervals are shown in seconds. The default value is 60 seconds and the
maximum is 3600 seconds (1 hour). There is enough data capacity to run for
6 days at 1-second intervals, 12 months at 60-second intervals, or 6 years at
10-minute intervals. Once the datalog is full, it cycles and begins to replace
the oldest data.
To change the Datalog Interval, press the Up or Mode key to increase or decrease each digit’s value,
and the Right or Left key to move the cursor. Then move the cursor to ‘
√
’ and press Up to save
and exit.
Monitor (Mnt) Setup
Several settings can be accessed here,
including date and time, pump
parameters, display parameters and
selecting 3-point calibration.
Date and Time
Date
The date is expressed as Month/Day/Year, with two digits for each. To
change the date press the Up or Mode key to increase or decrease each
digit’s value, and the Right or Left key to move the cursor. Move the
cursor to ‘
√
’ after the setting is complete, and press Up to save and exit.
Time
The Time is expressed as Hours/Minutes/Seconds, with two digits for
each. The time is in 24-hour (military) format. Adjust the time in the
same manner as for the date.
Display
The Display function is used to set LCD contrast and backlight.
LCD Contrast
The default LCD Contrast is about 50%.
To change the contrast, press the Up or Mode key to increase or decrease the digit’s value, then
move the cursor to ‘
√
’ and press Up to save and exit.
Set Interval Time
_ _ 6 0 s
√ ×
Date(MM/DD/YYYY)
11/20/2018
√ ×
Time(HH:MM:SS)
11:20:18
√ ×
