13
temperature has to be adapted, depending upon type of glass application. As
the differential temperature may exceed the admissible limit values and bursts
may occur. Delta T value has to be adapted to the corresponding application.
Therefore please see chapter
Comfort menu.
-
Do not kink the hoses.
-
Check hoses in regular intervals for material fatigue (e.g. cracks).
With water cooled units please pay special attention to the maximum operating
temperature and differential pressure requirements for the cooling water. Therefore
please refer to the technical data sheet.
Danger!
If the cooling water contains high levels of minerals, e.g. chloride, bromide then suitable
water treatment chemicals should be used. Use only recommended materials to
maintain the unit warranty. Further information on corrosion, (appearance and
avoidance) can be found on our website
www.huber-online.com
under "Download /
Safety data sheets thermofluids / Characteristics of water".
Please refer to the sections on
Intended use and general safety instructions.
Location
Caution!
-
Transport the unit upright.
-
The unit should be mounted in an upright and secure position, on a solid, stable
surface.
-
Place on a non flammable surface.
-
Keep the area around the unit clean, to avoid slip and trip hazards.
-
Set the brakes on the castors once the unit is in position.
-
Place suitable absorbent material under the unit to catch any condensate and
thermal fluid spills.
-
Any spillage of thermal fluid should be immediately cleaned up.
-
For large units, check the weight / load capacity for the flooring