MP Filtri UFM Series, Руководство по эксплуатации и обслуживанию

Страница: 24 / 136

In this case immerse the metal suction lances (IN) and the discharge lances (OUT) in the barrel or tank to be transferred to. Be
careful that the lances remain below the level of the oil to be transferred in order to avoid foaming and cavitation; space the ends
of the two lances in order to recirculate all the fluid and not generate an emulsion.
FILTRATION
Immerse the metal lances for suction (IN) and for discharge (OUT) inside the tank far from each other, if possible positioning them
at different heights (100 mm suction from the bottom of the tank, discharge immersed a minimum of 200 mm).
Make sure that the tubes/lances are properly fixed or perfectly stable before starting.
Be careful not to mix up the suction and discharge hoses. The suction hose (IN) is the one with the largest diameter.
6.4.2 Power on
Connect to the power supply
Insert the electric plug into a single-phase socket. 1
Once inserted, press the power on button "I" located on the terminal box of the electric motor (Fig. 1).
At this point the transfer and filtration of the fluid begins.
2
Fig.1
Power On/Off button
The discharge lance must in general have unrestricted flow. It is prohibited to install taps or components on both
hoses that may obstruct or reduce the flow of the fluid.
CAUTION
!
CAUTION
!
Before starting up the electric motor, make sure that the suction lance (IN) is immersed in the fluid.
6.4.3 Air vent - not applicable for UFM015
6.4.4 Oil analysis with particle counter - not applicable for UFM015
Mobile filtration unit
22