MP Filtri LPA3, Руководство оператора

Страница: 29 / 48

PRODUCT OPERATION
5.2.8 Pressure readout
Item 5, fi g. 5.3.
Denotation of suffi cient/insuffi cient pressure at time of test is given
as a green tick icon or a red X icon respectively.
5.2.9 RH result
Item 6, fi g. 5.3. If the product has the optional water sensor fi tted (W version), then
the last RH test result will be displayed here. The W sensor can be enabled/ disabled
in the settings screen as detailed in section 5.3.6
5.2.10 Temperature result
Item 7, fi g. 5.3.
If the product has the optional water sensor fi tted (W version), then
the last temperature result taken will be displayed here.
The W sensor can be enabled/ disabled in the settings screen as detailed in section
5.3.6.
Pressing the temperature result, will alternate the reading between degrees
Centigrade and Fahrenheit.
5.2.11 Battery status charge
Item 8, fi g. 5.3. The charge percentage level is shown here in the top right corner of
the home screen. The colour of the battery matches that of the LED:
Green - Higher than 70% level of charge remaining
Yellow - Between 20-70% charge
Red - Below 20% charge
The graphic also shows an estimated time associated with the charge remaining in
the battery.
5.2.12 Power icon
Item 9, fi g. 5.3. Pressing this button turns off the unit (this can also be done by
pressing the physical switch on the side). When the unit is charging, selecting this
icon will put the unit into standby mode where a battery symbol in the middle of the
screen will show the current level of charge (fi g. 5.12).
The icon will also be shown on the standby screen and can be used to access the
home screen.
Figure 5.7
Figure 5.8
Figure 5.10
Figure 5.12
Figure 5.11
Figure 5.9
Automatic Particle Counters
27