MP Filtri LPA3, Руководство оператора

Страница: 25 / 48

PRODUCT INSTALLATION
5.1.2 Electrical interface
The power on/off button is located at the side of the unit, see Figure 5.1.
Pressing this will cause the LPA3 to switch ON and startup screen will show on the display, see Figure 5.2.
The button also contains a Tri colour LED that will show the status of the unit relating to the amount of charge left in the
battery, colour denotations are shown below:
Green - Higher than 70% level of charge remaining
Yellow - Between 20-70% charge
Red - Below 20% charge
The charging port for the internal lithium ion battery is located directly below the power switch.
To engage the power connector, you must align the white arrow on the cable connector with the white line at the top of
the chassis plug on the device itself.
One should engage this fully and then rotate approximately 60° clockwise.
Reverse this action to remove the power charge cable.
Note: The LPA3 status of ‘charging’ is shown by a flashing LED.
The LPA3 is designed as a standalone portable unit. However, if you wish to connect the product to a computer and
utilise the product with its LPA-View software then this can be done via a standard A to B USB cable (this is provided
with the unit).
The cable is plugged in to the forward most USB connector as shown in the image above (figure 6.1). The other end of
the cable can then be connected to a PC that has MP Filtri’s bespoke LPA View software loaded for communication/log
download/remote control.
Please see document 200.054 for further information on using the LPA-View software.
There is also an option to expedite the log download direct to a USB memory stick. An FAT32 formatted memory stick
can be plugged to the ‘A type’ connector located on the side of the unit, to the left of the PC connection.
To ensure IP rating of the product is always met, caps for the USB connection
MUST be reconnected after use
NOTE
!
Automatic Particle Counters
23