LITESPEED RX
OWNERS MANUAL
16
Version 2
11.
Fit aluminium cup of the tip lever to the end of the tip rod and tension tip by rotating
the flat end of the tip lever inboard. For extra leverage, place your thumb through the
loop that is attached to the end of the tip lever. Make sure the tip lever is locked
against the tip rod. Close the zipper.
Picture 15
Tension the fibre glass wing tip.
12.
Insert the remaining mainsail battens, 7 to 11.
13.
Locate the inner and outer wire braced dive struts by placing them inside the sail,
below the webbing loop. Note that the action of closing the cord-wise zipper creates
the loop necessary to hold the strut in place.
14.
Insert the under surface battens (blue) into their respective pockets.
15.
Fit the nose fairing using the Velcro to keep a clean trim finish.
Picture 16
Fitting the nose cone.
Make sure the tip lever is consistent on both sides. The tip lever should either
be above or below the tip rod when locked in place.
NOTE
!
Do not forget this step as it is necessary for stability.
IMPORTANT
!
Содержание Litespeed RX 3
