Moyer Diebel 201HT M4 Series, Руководство по установке и эксплуатации

Страница: 55 / 120

Operation - 201LT
UL130 - Operation
1. Close the dishwasher front door.
2. Push the dishwasher Power Switch UP to turn the power ON.
3. The power switch will illuminate and the machine will fill with water.
4. Wait until the wash temperature gauge indicates a minimum of 120ºF/49ºC.
RUN THE FIRST CYCLE WITH AN EMPTY DISH RACK TO HEAT
THE WASH TANK INTERIOR.
5. Load the dish rack into the machine. Wash one dish rack at a time.
6. Close the door, then press the START BUTTON for 1 second. The green in-cycle
light will illuminate and the wash cycle will begin. The total cycle is approximately
141 seconds.
7. Opening the door during a cycle will stop the dishwasher. If the door is open more
than 5 seconds the cycle will restart from the beginning, if open less than 5 seconds
the cycle
will resume where it left off when the dishwasher door is closed.
8. The final rinse cycle begins at the end of the wash cycle. The machine drains and
then refills with fresh water hot water. Check the rinse temperature gauge during
the final rinse. It must indicate a minimum of 120ºF/49ºC. The final rinse water is
retained for the next wash cycle.
9. When the green cycle light goes out, open the door and remove the rack of clean
wares.
Normal Wash Mode
! VERY IMPORTANT !
5.25% sodium hypochlorite (chlorine beach) must be used as a sanitizing agent to
provide a minimum concentration of 50 ppm in the final rinse for the USA and 100 ppm
in Ontario, Canada. The 50 ppm or 100 ppm concentration must be
checked using chlorine test strips to make sure that the concentration is maintained.
Combination Wash and Final
Rinse Temperature Gauge
Prime
Push buttons
Cycle Light
Start
Push button
ON-OFF/DRAIN
Power Switch
Vari-Cycle
Delime Switch
and Light
120
100
80
60
40
20
0
140
160
180
200
210
220
40
60
100
80
1110
120
C
F
20
0
-20
NSF
47