WDR-3124A
Introduction
1-11
2.
Mounting the WDR-3124A to a wall requires 4 screws. Use the WDR-3124A device,
with wall mount plates attached as a guide, to mark the correct locations of the 4
screws. The heads of the screws should be less than 6.0 mm in diameter, and the
shafts should be less than 3.5 mm in diameter, as shown in the figure at the right.
NOTE
Test the screw head and shank size by inserting the screw into one of the keyhole shaped apertures of the Wall
Mounting Plates before it is screwed into the wall.
3.
Once the screws are fixed into the wall, insert the four screw
heads through the large opening of the keyhole-shaped
apertures, and then slide the WDR-3124A downwards, as
indicated in the accompanying diagram. Tighten the four screws
for added stability.
WARNING
•
This equipment is intended to be used in a Restricted Access Location, such as a dedicated computer room.
Access can only be gained by SERVICE PERSONS or by USERS who have been instructed about the fact that
the metal chassis of the equipment is extremely hot and may cause burns.
•
Service persons or users should pay special attention and take special precautions before handling the
equipment.
•
Access should be controlled with lock and key, or a security identity system controlled by the authority
responsible for the location. Only authorized, well-trained professionals should be allowed to access the
restricted access location.
•
External metal parts are hot!! Pay special attention or use special protection before handling.
Grounding the WDR-3124A
Grounding and wire routing help limit the effects of noise due to electromagnetic interference (EMI). Run the
ground connection from the ground screw to the grounding surface prior to connecting devices.
ATTENTION
This product is intended to be mounted to a well-grounded mounting surface, such as a metal panel.
