ioLogik R2140
Using ioAdmin
3-4
When you click Start Search, ioAdmin will begin searching up to 99 ports for your ioLogik unit. The timeout
interval is for RS-485 communication and defaults to 2000 ms. As soon as your ioLogik R2140 appears as shown
below, you may click Stop. Otherwise, ioAdmin will continue to search all 99 ports.
ATTENTION
If ioAdmin is unable to find your ioLogik R2140, make sure that the baudrates match. Please refer to Chapter
2 for setting or viewing the baudrate.
ATTENTION
Even if ioAdmin is unable to find your ioLogik R2140, you may still access the On-line Wiring Guide. Please refer
to the On-line Wiring Guide section for details.
Once the ioLogik R2140 has been found by ioAdmin, you may monitor I/O status from the first tab of ioAdmin.
You can also configure each AI and AO channel from this tab after first logging in under the Management tab.
