- 9 -
Arrester Accessories
•
SA-NMNF-01:
Surge arrester, N-type (male) to N-type (female)
•
SA-NFNF-01:
Surge arrester, N-type (female) to N-type (female)
Wiring the Redundant Power Inputs
The top two pairs of contacts of the 10-contact terminal block connector
on the AWK-1137C’s top panel are used for the AWK-1137C’s two DC
inputs. The top and front views of the terminal block connector are shown
below:
STEP 1:
Insert the negative/positive DC wires into the
V-/V+ terminals.
STEP 2:
To keep the DC wires from pulling loose, use a
small flat-blade screwdriver to tighten the
wire-clamp screws on the front of the terminal
block connector.
STEP 3:
Insert the plastic terminal block connector
prongs into the terminal block receptor, which is
located on the AWK-1137C’s side panel.
NOTE
Input Terminal Block (CN1) is suitable for wire size range of
12-28 AWG (3.31-0.0804 mm²) and a torque value of 4.5 lb-in
(0.51 Nm)
ATTENTION
If the AWK-1137C is connected to a motor or other similar type of
equipment, be sure to use power isolation protection. Before
connecting the AWK-1137C to the DC power inputs, make sure
the DC power source voltage is stable.
Using the Reset Button
The
Reset
button is used to load the factory default settings. Use a
pointed object to hold the
Reset
button down for five seconds to load the
factory defaults.
Activating AeroMag Function
Push the
Reset
Button five times to activate AeroMag. To deactivate it
again, push the
Reset
Button three times.
