1. POSITIONING THE
MOUNTING BRACKETS
2. WHEN TO USE
MOUNTING BLOCKS
3. FITTING MOUNTING
BRACKETS
4. UNFOLDING BUGGYPOD®
The mounting brackets (e) should
be fitted to two major chassis tubes
on the right hand side of the host
pushchair, between 14 to 37.5 cm apart,
and approximately 29 to 41cm from
the floor.
NOTE! The front bracket can be
fitted up to approx. 8 cm higher than
the rear bracket if it helps provide a
good connection. The
Buggypod
®
seat
will then tilt back slightly, as with
pushchairs, and you may in any case
prefer that.
NOTE! The mounting brackets (e)
should not interfere with the braking
system or folding mechanism of your
pushchair.
If you want to make any changes to
the position of the mounting bracket,
loosen the steel band screw with a
screwdriver, re-position the mounting
bracket and re-tighten. You should try
to re-position the mounting brackets
if they interfere with the braking or
folding mechanism of the pushchair.
The mounting blocks
(k) should be used
when fitting the
mounting brackets
(e) to square-shaped
tubing or thin tubing
with a diameter less
than 18mm. They can also be used
tohelp clear folding mechanisms if
the brackets interfere with folding
the pushchair without the block fitted.
When fitting to square tubing, allow
the bracket to point diagonally to the
rear or front so that the mounting
block fits snug to the edge of
the tubing. (see www.buggypod.com/
support_fitting.php)
a.
Rotate the green button head of
the mounting bracket so that it is
vertical (or perpendicular to the
connector bar (c) if front bracket is
attached higher than rear bracket).
b.
Tighten the green button head with
the supplied large allen key (h)
inserted into the hole between
the buttons.
THIS MUST BE TIGHT BEFORE USE !
Once you have identified suitable
locations for the mounting brackets,
remove the green PVC cap from the
steel band tip on the mounting bracket,
turn the screw anti-clockwise to release
the bracket band from the bracket, then
wrap the steel band with the pre-fitted
black PVC friction sleeve around the
tubing at the selected height and
feed the band tip back into the
screw housing.
NOTE! Depending on the diameter
of the tubing, you should shorten the
friction sleeve with scissors so that it
does not interfere with tightening the
mounting bracket.
Fold open Buggypod® by simply
pulling backrest and leg apart.
The two rear locks should close
automatically
Tighten the band screw with a
flat-headed or 7mm hex-headed
screwdriver / spanner.
Slide wheel (ib) onto wheel axle until
it locks.
COMPONENTS/KOMPONENTEN/COMPONENTES
LA
IB
I
K
G
E
H
O
C
IP
Buggypod lite box contents:
1. Buggypod® lite frame and seat (part LA)
2. Wheel (IB)
3. Connector bar (C) and Mounting boss x 2 (G), prefitted to Buggypod
®
4. Mounting bracket, standard size x 2 (E)
5. Mounting block x 2 (K)
6. Allen key, small x 1 and large x 1 (H)
7. Leash (O)
8. End plug x 2 (I), pre-fitted to Buggypod
®
9. Hinge (IP)
10. User Guide
For your convenience, the Buggypod
®
is supplied partially assembled.
2
3
140 - 375mm
