Motus M990T, Руководство по обслуживанию

Страница: 6 / 105

5
1.2 Troubleshooting Guide
SYMPTOM PROBABLE CAUSE CORRECTIVE ACTION
Line voltage is not present at treadmill.
Check the main circuit breaker and wall outlet voltage at
the Facility.
If wall outlet voltage is present, then replace line cord.
Circuit breaker on the rear of the Treadmill Is tripped.
(Countries using 220V or 230V Supply Voltage)
If tripped, a white button has popped out. Press the white
button to reset the circuit breaker after eliminating the
cause of the trip. The circuit breaker is located next to
power ON/OFF switch on the outside of the treadmill.
Power-on switch with built-in circuit breaker is tripped.
(US/Canada market or Japan market using 100V or 120V
Supply Voltage)
In the United States, Canada and Japan, circuit breaker
is combined with power ON/OFF switch. If tripped, the
switch is turned to OFF position. Turn the switch on after
eliminating the cause of the trip. Replace it if necessary
Power-on Switch is damaged.
Replace Power-on Switch if the output voltage of Power
Switch is not present.
Defective Line Filter.
Replace Line Filter if the output of Line Filter is not
present.
Electronic components of Lift/Power Supply PCB are damaged.
Disconnect CN3 cable at Lift/Power Supply PCB and
then measure the voltage between pin 2 and pin 1.
Measure the voltage between pin 2 and pin 3. The
voltage should be 5VDC. If there is no voltage, replace
the PCB.
No power to
treadmill console
Fuses 1, 2 on Lift/Power Supply PCB are blown. Replace Fuses or the PCB.