Motus M990T, Руководство по обслуживанию

Страница: 17 / 105

16
‘INCLINE
▽
’ -> ‘INCLINE
△
’ -> ‘SPEED
▽
’ -> ‘SPEED
△
’ -> ‘ENTER’
Keep in mind that this step must be done after filling the tank fully.
7) The warning SYMBOL and beep disappears.
How to inject lubricant manually (M995T, M995TL)
To judge proper lubrication timing, you can feel the friction intensity by pushing the striding belt backward using your feet while holding the front
handle after turn OFF the treadmill.
1. Fill the lubricator with the oil Motus provided.
2. The conduction hole for the lubrication is at the right corner on the front of the treadmill as shown in the picture.
3. Insert the pipe tip of the lubricant to the end through the conduction hole to spread out the lubricant on the center of the belt.
4. Inject the lubricant into the conduction hole by squeezing the lubricator about 20 times under the belt speed of 4km.
The amount of 30 cc is recommended.
5. To spread out the lubricant all round on the belt, operate the treadmill for a few minutes.
6. Lubricate more than twice a month.
How to eliminate warning beep & symbol requiring lubrication (M995T, M995TL)
Although lubricant is not injected automatically, lubrication interval can be set up at Manager Mode, for instance, 500km
.
If the interval is too short or
long, you can adjust the interval at Manager Mode. Warning beep & symbol every lubrication interval makes you easy to lubricate without any need
to consider lubrication timing.
To reset the warning beep and symbol after completing manual lubrication, press buttons in the order as below.
‘INCLINE
▽
’ -> ‘INCLINE
△
’ -> ‘SPEED
▽
’ -> ‘SPEED
△
’ -> ‘ENTER’
The warning beep and SYMBOL disappear.