Motus M990T, Руководство по обслуживанию

Страница: 15 / 105

14
- Regenerative energy from motor is too much. compulsorily by foot.
E60
Communication
Error
- External noise
- Trouble in internal memory due to or high temperature.
- Cable connection between MPU and Motor Controller
- Replace Motor Controller cable with
new one
- Replace Motor Controller with new
one
E09 Low voltage
Unexpected low voltage is detected at DC voltage of Motor
Controller.
- Input voltage of Motor Controller is too low.
- Instantaneous power failure - Check the input voltage to treadmill.
- Connect the treadmill to dedicated
circuit.
- Supply stable power to treadmill
E34
Short-circuited
output Excessive current flows in Motor Controller when the output of
Motor Controller is short
- Check the cables and wires between
motor and Motor Controller are loose
or if there is any short circuit between
wires.
E08 EEPROM
Trouble in internal EEPROM due to high temperature. A lot of
parameters are saved in the EEPROM.
- Make a service call.
E12
Tripped out due
to external input
signal
Failure caused intentionally by input terminal. It is not
implemented in the treadmill.
Replace the Motor Controller
E14 Ground fault trip
Grounding protection when an Motor Controller output line
dropped to earth. Current leaks from an output cable or the motor
to ground. - Check the cables and wires from
Motor Controller are dropped to the
earth
The temperature of power module in Motor Controller is too high.
- Ambient temperature is too high.
- Do not place heat generating device
near the treadmill.
E21 Temperature trip
Overheated Motor Controller caused by worn or damaged belt and
deck.
Replace the deck or belt.