Motus M990T, Руководство по обслуживанию

Страница: 22 / 105

21
getting damaged, stop the treadmill and contact authorized local dealer.
2.2.2 When the belt is diagonally tilted
When the Striding Belt is diagonally
tilted as shown, the Front Roller (F4)
needs to be aligned by following
steps.
1) Turn off the unit power at the
switch and then unplug the line cord
at wall outlet.
2) Remove three Motor Cover
screws (B20) and then lift the cover
(T1) out from between the upright Supports.
3) Turn the Hex Bolt (B2) in either
direction to compensate for the tilted
Striding Belt.
When the Striding Belt is tilted as
shown in A), turn the Hex Bolt (B2)
by 1/4 turn in the direction of (1).
When the Striding Belt is tilted as
shown in B), turn the Hex Bolt (B2)
by 1/4 turn in the direction of (2).
Note: Make adjustments in 1/4
turn.
The position of the Front Roller to be changed by the direction of the Hex Bolt (B2) is indicated
in the figure.
4) Re-assemble the Motor Cover in
the reverse order of removal and
make sure that the Striding Belt is
properly aligned after turning on the
unit power and operating it with the
speed of 5km/h for a few minutes..
5) Repeat this adjustment until the
Striding Belt is properly aligned.