8
FIXING THE CHAIN
•
On the gate, mark the distance of 110
mm between the anchoring base surface
and the bracket-securing holes.
•
Make two 11 mm-diameter horizontal
holes with 30 mm between them.
•
Insert the bushings into the holes and
secure the bracket with screws and wash-
ers.
•
Secure the second bracket from the other
end of the gate, following the procedures
above.
•
Secure the chain onto the bracket using
the tie rods, nuts, washers and the hooks
supplied.
•
Secure the other end of the chain or, as
described above, cutting off any excess.
Pre-tension the chain with a 13 mm wrench
(Ref.
1
).
N.B.:
: should the gate not have a suitable
end (tail) to allow the gate to complete its
closing run, use the extension bracket (Ref.
2
) supplied.
30mm
110 mm
Ref.
1
Ref.
2
