Motortech SparkView, Руководство по эксплуатации

Страница: 25 / 34

5 Operation
Rev. 12/2019 25
▸ The voltage display of the SparkView high voltage indicator shows the measured
voltage.
SparkScan1: No permanent measurement
The SparkScan1 high voltage clamp is designed for temporary measure-
ments of high voltages and must not remain on the spark plug lead perma-
nently.
5.4.2 Measuring on Ignition Coil with Diagnostic Interface
The SparkView high voltage indicator is suitable for high voltage measurements with a BNC
cable from MOTORTECH not exceeding 3 m (118"). Before taking measurements via the diagnos-
tic interface of an ignition coil, read the installation instruction supplied with the ignition coil
with diagnostic interface. Then proceed as follows:
1. Switch on the SparkView high voltage indicator by pressing the on/off button . The
SparkView calibrates itself when it is switched on.
2. Press and hold the SET button and use the adjustment buttons to adjust the red
and the yellow range.
▸ The setting is saved for the currently set measuring range and is retained when the
SparkView is restarted.
3. Connect the device using a BNC cable from MOTORTECH to a MOTORTECH ignition coil with a
BNC diagnostic interface.
Risk of damage!
Hot engine parts can damage the BNC cable or the SparkView high voltage
indicator. Avoid contact of the products with hot spots. Do not use damaged
products.