Status-Bits EN
P920380 - MIC6
Revision: 33493
General Status 2
32
4
Error
No. Name
K
Description/Comments
1
General Error
a/n
General error. See message log for details.
In case of an operational error the error can be
acknowledged. In case of a system error the device has
to be restarted.
2
Overspeed
a
Overspeed
3
Pickup Signal in Self-Test Detected
a
The self-test was aborted because pickup signal activity
has been detected.
4
Alarm Shutdown
a
The ignition was shutdown because of an alarm.
5
Output Board Identification Failed
n
Output board identification data could not be read,are
defective or do not match the device.
6
Power Failure
n
The high voltage power supply has signaled a failure.
7
Temperature Sensor Failure
n
An error occurred while reading a temperature sensor.
8
Current Sensor Failure
n
During current measurement an error occurred.
9
Temperature Limit Exceeded
a
The error is triggered if the device temperature exceeds
120 °C (248 °F) or if it exceeds 110 °C (230 °F) for
10 minutes.
10
Power Output Limit Exceeded
a
The error is triggered if the power output exceeds 244 W
or if it exceeds 224 W for 3 minutes.
If the supply voltage is below 17 V this error occurs also
with lower power output.
11
Device Started After Supply Voltage
Failure
a
The device was started or powered on again after a
supply voltage failure.
12..
32
reserved (for future use)
-
-
5
Pickup Status
Pickup status bits are set on the respective condition.
Status bits set during synchronization get automatically reset after successful synchronization. If the
synchronization fails, the bits are reset at the beginning of the next synchronization.
If status bits are set during operation but not for an operational error, these bits will be reset automatically
during operation or when the engine stopped. In case of an operational error the status bits will be active
until the error has been acknowledged.
Exceptions are noted in the table.
The following status bits are available for every pickup input.
No. Name
K
Description/Comments
1
Synchronization Problem
i
Failed to synchronize to this signal or this signal
combined with another input prevented the system from
synchronization.
2
Operational Error
a
A signal (or timeout) on this input caused an operational
7 / 8
