Installation
B
QIP7000 (P2) Series Hybrid QAM/IP HD Set-top Terminal • Installation Manual
22
574702-001 a
This document is uncontrolled pending incorporation in a Motorola CMS
Installation Overview
1.
Determine if you are connecting to a:
High-Definition
TV or monitor
Use the component video (YPbPr), HDMI, or IEEE-1394 outputs. No other video
connection supports HDTV.
If the TV has no HDMI input but does have a DVI input, connect a DVI-to-HDMI
adapter or cable to the HDMI out connector on the QIP set-top instead of the
IEEE-1394 connection, and the DVI-HDTV connector on your TV.
Standard-
Definition TV
Connect the S-Video connector using an S-video cable, or connect the
composite video connector using a composite (RCA phono) cable. If the TV only
has a coaxial RF input, connect it to the QIP7000 series RF OUT connector.
2.
Determine if you are connecting the audio to a home theater receiver or directly to
the TV:
For an HDMI or IEEE-1394 video connection, no additional audio connections to
the TV are required.
For a DVI video connection, additional audio connections to the TV are required.
If the receiver or TV has a digital audio (S/PDIF) input, use the digital audio
OPTICAL (S/PDIF) or COAXIAL (S/PDIF) outputs.
Otherwise, use the baseband left and right audio outputs.
3.
Locate the cabling diagram(s) that best match the subscriber’s configuration.
4.
Connect the audio and video cables in a manner matching that diagram.
5.
Determine if you are connecting to a data device (see Data Device Connections in
this section). For installation details, refer to the instructions included with the data
device.
6.
Connect the cable terminal to the coaxial cable wall outlet.
7.
Perform the operational check for the remote control.
8.
Optimize the high-definition settings. See
Optimizing the High-Definition Settings
in
this section.
