Motorola MVME167P, Инструкция по установке и эксплуатации

Страница: 41 / 120

Bringing up the Board
http://www.motorola.com/computer/literature 2-5
2
Control/Status register. (The MVME1X7P Single Board
Computers Programmer’s Reference Guide has additional
information.) The bit values are read as a 0 when the jumper is on,
or as a 1 when the jumper is off.
The default configuration has J1 set to all 0s (all jumpers
installed). The 167Bug firmware reserves/defines the four lower
order bits (GPI0 to GPI3, pins 1-2 to 7-8).
Table 2-2 describes the
bit assignments on J1.
2. Configure header J6 as appropriate for the desired system
controller functionality (always system controller, never system
controller, or self-regulating) on the MVME167P.
3. The jumpers on header J9 establish the SRAM backup power
source on the MVME167P. The factory configuration uses
5V standby voltage as the primary and secondary
power source (the onboard battery is disconnected). Verify that
this configuration is appropriate for your application.
4. Headers J10 and J11 configure serial port 4 to drive or receive
clock signals provided by the RTXC and TRXC signal lines. The
MVME167P factory configuration has port 4 set to receive both
signals. Refer to the instructions in Chapter 1 if your application
requires reconfiguring port 4.
5. Verify that the settings of configuration switches S3 (Petra
SDRAM size) and S4 (board EPROM/Flash mode) are
appropriate for your memory controller emulation.
6. Refer to the setup procedure for your particular chassis or system
for details concerning the installation of the MVME167P.
7. Connect the terminal to be used as the 167Bug system console to
the default EIA-232-D port at MVME167P Serial Port 1 (Serial
Port 2 on the MVME712M transition module). Set the terminal up
as follows:
❏
Eight bits per character
❏
One stop bit per character