Motorola MP6000, Руководство интегратора

Страница: 141 / 210

SCALE CALIBRATION (MODELS WITH A SCALE ONLY) 4 - 11
The weight checked at each position on the scale, shown in Figure 4-4 , represent halfway between the center
of the platter and corner. Use a stack configuration of weights if needed (i.e., (2) 5.00 lb weights, or (2) 2.500 kg
weights) depending on the units of measure programmed.
Figure 4-4
Weight Positions on the Scale Platter
While performing a shift test, the indication of each position is within the applicable tolerance and the range of
results obtained should not exceed twice the applicable tolerance.
Audit Tallies
Audit Tallies (calibration counter = C, legal parameter counter = P) used for scale verification can be shown on
the Scale Display, or the 7-segment display.
1.
Press and hold the Scale Zero button for three seconds to access the calibration tallies (not within
Calibration mode).
a.
C### and P### tallies blink on the Scale Display and/or scroll on the 7-segment display.
i.
C###
represents the number of times the scale reached Calibration Success on page 4-7 . (Only
successful calibrations are counted.)
ii.
The P### represents the number of times any sealable parameter, or legal parameter was
changed with or without reaching Calibration Success on page 4-7 .
Scale Platter
Shaded Area
Represents the
Horizontal Window
IMPORTANT After verification, record/report audit trail information to the local Weights and Measure authority
where required by law.