Motorola ME-560M, Руководство пользователя, Страница: 47 / 58

Connect message displays
\V0 = Connect message are controlled by commands X and W only (note: S95 is not supported); (Default)
\V1 = Connect messages are displayed in single line format which captures all the information associated
with the call established. Connect, DTE speed, Modulation etc. are all displayed if applicable. See
examples listed below.
W0 = Reports DTE speed only; (Default)
W1 = Reports Protocol and DTE speed in 2 separate lines;
W2 = Reports DCE speed only.
Regarding the DTE or DCE speed ortion’ of the connect message in both \V0 and \V1 cases:
For X0, no matter what DTE or DCE speed, a simple CONNECT message is displayed.
For X1, X2, X3 and X4, if DTE or DCE speed is 300 bps, a simple CONNECT is displayed, otherwise a
CONNECT together with a speed is displayed.
Notes :
(a)
x = Don care
(b)
Deafult is \V0, W0 and X4.
\V W X CON-
NECT
DTE-
speed
Modulat
ion
Pro-
tocol
Com-
Pression
DCE
speed
\V0 W0 X4
√ √
\V0 W1 X4
√ √ √
\V0 W2 X4
√ √
\V1 x x
√ √ √ √ √ √
\V1 x x
√ √ √ √ √ √
\V1 x x
√ √ √ √ √ √
\V0 W0 X0
√
\V0 W1 X0
√ √
\V0 W2 X0
√
\V0 W0 X1
√ √
\V0 W1 X1
√ √ √
\V0 W2 X1
√ √
\V0 W0 X2
√ √
\V0 W1 X2
√ √ √
\V0 W2 X2
√ √
\V0 W0 X3
√ √
\V0 W1 X3
√ √ √
\V0 W2 X3
√ √
•
Assuming result code return is enabled (ATQ0).
•
Assuming long form result code (ATV1).
•
Modulation = K56FLEX, V.34, V.32 or omitted for all other modulation modes.
•
Protocol = NONE, ALT or LAPM.
•
Compression = CLASS5 or V42BIS or omitted when protocol is NONE.
•
For K56FLEX, V.34 and V.23 where asymmetric rates are possible, DCE speed = DCE speed:TX/DCE
speed:RX (note: both :TX and :RX are always shown even though the two rates may be the same);
For all other modulation modes, DCE speed = single DCE speed (i.e. with no :TX or :RX attached to the
rate).
Examples :
(DTE rate = 115.2 Kbps)