Motorola HMEZ2000 - Homesight Wireless Home Security Monitoring, Руководство пользователя

Страница: 18 / 145

11 Motorola homesight ™ USER GUIDE
Tasks
In this section, you will learn how to add and remove devices; capture, view, and delete images and videos; reset devices; and even uninstall the software.
Add a Sensor
1. Bring the sensor into the same room where the Motorola Wireless System Controller is connected to your computer.
2. Make sure that the sensor has fresh batteries.
3. Make sure that the controller is plugged in to your computer's USB port, power is connected to the controller, and your Motorola homesight Software
system is running.
4. Click on the SYSTEM SETTINGS button and then the Device Discovery entry to display the Discovery screen.
5. Click on the START DISCOVERY button. Check for the discovery is in progress message at the top of the device list.
6. The Motorola homesight Software system will begin listening for device registration messages from the wireless devices (such as sensors) that you wish
to add to your system.
7. Refer to the diagram below to locate the sensor's discovery button. The discovery button is a recessed, momentary contact switch that is located on the
back or the underside of the sensor.
8. Use the tip of the 'discovery tool' included with the device to momentarily press and then release the discovery switch (do this once only). A light on the
sensor will briefly turn green, and then turn off to indicate that the controller has registered the sensor.
9. After a few moments, an entry for the sensor should appear in the device list, including a green device icon and a default device name.
10. If the sensor entry does not appear in the list within one minute, repeat steps 8 and 9.
11. Repeat steps 7 through 10 for each additional sensor that you wish to add to your system.
12. Click on the STOP DISCOVERY button. Check for the discovery stopped message at the top of the device list.
13. Click on the DEVICE OVERVIEW button to display the Device Overview screen.
14. For each sensor that you added, click on the CONFIG icon in the device list to display the properties panel for that sensor. Change properties as desired
(for example, change the sensor name), then click on the OK button.
15. Test the operation of the sensor.
16. Once you have registered a sensor with the Motorola homesight Software system, you may move it to another location. The sensor's registration will be
retained, and it will not be necessary for you to rediscover the unit after it has been moved. Test the unit once it is installed in its new position.