Motorola ES400, Руководство пользователя

Страница: 75 / 212

Phone Network Setup 4 - 7
Call waiting notifies the user of an incoming call when the phone is in a phone session. Select the Notify me radio
button to enable call waiting. Select the Do not notify me radio button to disable call waiting.
Voice Mail and Text Messages
To use voice mail and send short messages, enter the voice mail and/or text message phone number in the
appropriate text boxes.
Fixed Dialing
Use Fixed Dialing to restrict the phone to dial only the phone number(s) or area code(s) specified in a Fixed Dialing
list.
1.
Select Fixed Dialing and tap Get Settings.
2.
Select the Enable fixed dialing check box.
3.
To add a number to the list, tap Menu > Add.
4.
Enter the phone number or area code to restrict and tap Done.
5.
Repeat steps 3 and 4 to add more numbers, and tap Done twice when complete.
6.
Enter PIN2 and tap Done.
Internet
Use the Internet tab to configure Internet calling.
Select an option from the down-down list.
Tap OK.
Broadcast Channels
Enable broadcast messages from local cell sites. These messages include emergency directions and information
services.
TTY
Use an optional TTY device with the ES400 to send and receive calls. Plug the TTY device into the ES400’s
headset jack and set the ES400 to operate in 1 of 3 TTY modes.
When you set the ES400 to a TTY mode, it operates in that mode whenever the TTY device is connected.
•
Headset - Transmit and receive TTY characters using a headset.
NOTE PIN2 is buffered in the ES400 indefinitely after entry and will not be requested again until a reboot of the
ES400 has been performed. Should PIN2 be required, then the user must perform a reboot of the ES400.
NOTE Use a TSB-121 compliant cable (provided by the TTY manufacturer) to connect the TTY device to the ES400.
Set the ES400 volume to a middle level setting for proper operation. If you experience a high number of
incorrect characters, adjust the volume as needed to minimize the error rate.
For optimal performance, the ES400 should be at least 12 inches (30 centimeters) from the TTY device.
Placing the ES400 too close to the TTY device may cause high error rates.